Installing Cured in Place Vent Stack Lining in San Francisco, California

pipe drain cleaning San Francisco California

San Francisco, California Cured in Place Vent Stack Lining

When faced with damaged vent stacks, most property owners opt to perform vent rehabilitation rather than replacement. Vent stack rehabilitation is only two-thirds the cost of replacement in San Francisco. This is because it only needs less people on the job and there is no need to destroy any part of the property when doing the repair. The cured in place pipe(CIPP) is a pipe rehabilitation system that can be done on vent stacks. This system uses fiberglass liner that’s inserted into the broken pipe which is then cured with ultraviolet light.

sewer camera inspection San Francisco California

Since the ventilation is one of the most important parts of a building, only professional contractors should be allowed to perform the lining process. A good team will start by cleaning dirt or debris from the pipe before starting to repair. A computer-controller robotic camera will then be used to conduct a thorough inspection of the vents. The crew can then view the video footage from the ground level and handle any potential problems before the vent stack lining installation.

San Francisco California camera inspections spt

A pre-liner will be pulled through the pipe after the inspection and prep work has been completed. The contractors will then attach a winch cable which pulls the fiberglass liner through the vent pipe. The end gates, now secured with heavy duty nylon straps, will then be placed inside each end of the liner to pressurize it. The liner is then slowly inflated.

After the inflation. Pressure will be reduced a 12-foot long train of 8 UV lights with a camera on the nose inserted in the upstream end of the liner through any of the end gates. The contractor will then attach a rope that has been manufactured inside the liner to the nose of the train before inserting it into the liner.

San Francisco California video inspect pipe

With the light train in place, the end gate can then be closed once more and the pressure brought back to normal (8psi). To visually inspect the liner for any problems before it is cured, the light train will be pulled. If the vent stack is in good condition, the UV lights will be lit on the train and a computer pull the light train back to monitor the curing process all the way. This is an important device that controls the temperature, speed and pressure of the entire curing process watched via a computer. The typical speed UV curing systems take to cure ranges between 4 to 8 foot per minute.

To finalize the process, contractors will remove the light train and end gates before they start trimming the liner ends. A cut will then be inserted and precision cuts made at each lateral to restore the service to the main.

Installing cured in place vent stack lining in San Francisco is the way to go. Property owners prefer this method since the breakdown of equipment is minimal. Time taken to complete the job is also minimized and the crew can be off the job and on to another one in a matter of minutes.

Call Now: 800-849-4610

Click to Call! arrow-down arrow-right arrow-up-right bubble checkmark cross envelope location menu phone play3 star-empty star-full star-half facebook folder google-plus instagram linkedin twitter user youtube pipe-3 pipe-4 pipe-5 pipe-6 pipe-7 pipe-12